2 0 0 5
B
B
oo
bb
LL
oo
nn
gg
ii
nn
tt
ii
mm
iidd
aa
ttoo
rr
BB
oo
bb
LL
oo
nn
gg
ii
nn
tt
ii
mm
ii
dd
aa
tt
oo
rr
A s s e m b l y a n d D i s a s s e m b l y
BODY DISASSEMBLY (continued)
8. Remove Air Barb from Back of Ram Sleeve. Do not lose fiber washer at base of Air Barb.
9. Remove Ram Sleeve retaining allen.
10. At this time you are ready to remove the Ram Sleeve from the body. When removing,
.
rotate the Ram Sleeve right and left pulling towards the rear of the Marker. Use caution
.
to avoid cutting the O-rings, as there are sharp edges the O-rings must pass through.
.
NOTE:
When reinstalling Ram Sleeve, it must be inserted through the front end
.
of the Lower Tube of the Marker Body in order to ensure a proper seal.
11a. Remove Feedneck by first removing Feedneck Collar, then removing Feedneck Base.
11b. Remove Feedneck Base from Body.
NOTE: At this time the Body is disassembled.
Listed on the following page are key points
to remember during assembly.
A s s e m b l y a n d D i s a s s e m b l y
III. BODY DISASSEMBLY
First:
Ensure Barrel of Marker is removed.
1. Remove both Eye Sensor Covers (one on each side) by removing Retaining Screw.
2. Remove both Eye Sensors (one on each side) by carefully pulling sensor heads from
mounting holes. Be careful not to lose small o-ring on each head.
3. Lift up on Bolt Retaining Pin and slide Bolt out of rear of Marker.
4. Remove Ram Sleeve Cap located at the rear of Marker. (turn counter-clockwise)
5. Turn Marker up and allow ram to slide out of Marker rear. Place hand underneath
to catch ram. Do not allow ram to fall freely onto ground or any other hard surface.
6. Turn Body over to gain access to the bottom of the Marker.
7. Remove Air Barb from Center of Ram Sleeve. Do not lose fiber washer at base of Air Barb.
Remove Eye Sensor Covers
1
Remove Eye Sensors
2
Turn Body over Exposing Bottom of Marker
6
Remove Center Barb
7
Remove Ram Sleeve Retaining Allen
9
Remove Ram Sleeve from Rear
10
Remove Feedneck Base
Remove Feedneck Collar
11a
11b
Lift Bolt Pin and Remove Bolt
Remove Ram Sleeve Cap
Remove Ram
3
4
5
Remove Rear Barb
8
15
16