This product conforms to EU Directive 2002/96/EC.
This appliance bears the symbol of the crossed waste bin. This indicates that, at the end of its useful life, it must not be
disposed of as domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment. It is
the user's responsibility to dispose of this appliance through the appropriate channels. Failure to do so may incur penalties
established by laws governing waste disposal.
BN Thermic Ltd,
34 Stephenson Way,
Crawley,
RH10 1TN
Tel: +44 (0) 1293 547361
Email: [email protected]
Web: www.bnthermic.co.uk
6. CONTROL
Standard temperature control is by adjusting the electronic thermostat knob located on the front of the heater.
Twist clockwise to increase temperature set point
Twist Anti-clockwise to decrease temperature set point.
7. MAINTENANCE
Note:
Before examining or carrying out any maintenance ensure the heater has cooled down and is disconnected from the mains
supply.
The heaters are intended to operate for many years, problem free. All moving parts are factory lubricated and therefore should
require no service. Maintenance is limited to keeping both the inlet and outlet areas free from any accumulation of dust or any other
foreign materials. This is especially important immediately before the heating season. Any dust build up can be loosened using a
brush and a vacuum cleaner applied to the airways to ensure completed removal of any dust. When the heater is first turned on
after cleaning an unusual odour may be noted this is due to the dust particles which inevitably will be disturbed and will be burnt off
from the heating element.
If in any doubt always consult a qualified electrician for advice.
8. AUTO CUT OUT
This heater is fitted with a semi-automatic safety device to prevent overheating. The device will isolate the heating element while
the fan continues to operate. Should this occur, disconnect the heater from the mains supply for a minimum of 5 minutes, check
and remove any foreign materials around the airways. If the heater fails to operate or the safety cut out operates again, turn off the
heater and contact a qualified electrician.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component
parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Your BN Thermic product is guaranteed for one year from date of purchase.
We will repair or replace at our discretion any part found to be defective. We cannot assume
any consequential liability. This guarantee in no way prejudices your rights under common
law and is offered as an addition to consumer liability rights.
REGISTER:
Activate your warranty by registering online at www.bnthermic.co.uk and
retain this installation data for future reference.
SCHG-30TINS-v01
