6 . I N S T A L L I N G A R E M O T E S E N S O R .
If you wish to place the thermostat in a separate area such as an adjacent room or cupboard from the room you are
heating, a remote sensor will be required to detect the temperature.
There are three different sensors available.
1) Black Bulb Sensor (Part No. BBS)
– Used for detecting the infrared heat given out by your heaters.
2) Black Bulb Sensor IP Rated (Part No. BBSIP)
– Used for detecting the infrared heat given out by your heaters but
is rated IP65 for use in damp, wet conditions.
3) Air Sensor (Part No. CXS)
– Used for detecting the air temperature.
Connecting a Remote Sensor
1)
Disconnect the thermostat’s built-in sensor wires making sure the wire ends cannot come into contact with anything
live by insulating them.
2) Using any insulated copper wire connect the remote sensor to the green sensor terminals marked J3 on the circuit
board as per picture.
7 . W I N D O W O P E N I N G .
There is an energy saving feature built into this controller if required. Should the
temperature suddenly drop indicating that an outside window or door is open, the heaters
will turn off for a short period of time before returning to full power.
This may be useful if you are using a single heater in a small room. By default, this function
is OFF but if you require it, just move switch No.2 to the ON position on the circuit board
when setting the thermostat.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and
component parts without prior notice.
REGISTER:
Activate your warranty by registering online at www.bnthermic.co.uk
and retain this installation data for future reference.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Your BN Thermic product is guaranteed for one year from date of
purchase. We will repair or replace at our discretion any part found to be defective.
We cannot assume any consequential liability. This guarantee in no way prejudices
your rights under common law and is offered as an addition to consumer liability
rights.
PROSTAT3-v01-1
This product conforms to EU Directive 2002/96/EC.
This appliance bears the symbol of the crossed waste bin. This indicates that, at the end of its useful life, it must not
be disposed of as domestic waste, but must be taken to a collection centre for waste electrical and electronic
equipment. It is the user's responsibility to dispose of this appliance through the appropriate channels. Failure to do
so may incur penalties established by laws governing waste disposal.
BN Thermic Ltd,
34 Stephenson Way,
Crawley, RH10 1TN
Tel: +44 (0) 1293 547361
Email: [email protected]
Web: www.bnthermic.co.uk
BBSIP Sensor
BBS Sensor
CXS Sensor
