BN Products BNT-25X, Operating Instructions Manual

Page: 7 / 12

Page | 7
Common Faults
Warning
Sound
Indicator
Light
Items To Inspect Possible Cause Actions
The machine does
not work after
putting in a new wire
spool.
None Off Inspect the battery
terminal Oxidation or there
is dirt on the elec-
trodes Use a dry cloth to
wipe the surfaces
Beep---- On Confirm that the bat-
tery is charged Low power in the
battery Recharge the bat-
tery
Beep,
Beep,Beep
On Off On
Off On off...
Check wire guide “A”
to see if there is stray
wire in the guide The head of the
wire was caught
in the guide Using a pair of pli-
ers remove the wire
Beep, Beep,
Beep, Beep...
On Off On
Off On off...
Check the curl guide to
see if there is a stray
wire caught in the tool Tying strength
may be too strong Adjust the tying
force and remove
the caught wire
The wire does not
feed correctly
Beep, Beep On Off On
Off On off...
Check the curl guide The curl guide is
open Close the curl guide
Beep, Beep,
Beep
On Off On
Off On off...
Check the diameter of
the rebars The diameter of
the rebar exceeds
chart Use the proper di-
ameter rebars
Beep, Beep,
Beep, Beep...
On Off On
Off On off...
Check the tightness of
the wire coil The wire is too
tight on the coil Clear the wire
Irregular binding and
wire stepping out of
the curl guide None On- Alarm when pressing
the trigger-- No alarm
when released Overheated motor
from constant use Let the motor cool
down
Failure to cut the
wire after binding
None On- Check if the wire hits
the rebar when tying The wire hitting
the rebar will stop
the action Pay attention so
that the wire does
not hit the rebar
Tying knot is loose
None On- Check to see if the
cutting mechanism is
working correctly There may be
a stray piece of
wire in the cutting
mechanism Clean the cutting
mechanism
None On- Check the operation
instruction Wrong operation Please read the
operation manual
Tying knot is not
correct None On- Check the tying
strength The tying force is
too great Adjust to the proper
tying force
Common Faults
This tool alerts you to the following fault conditions by means of a warning sound and warning light. If the
problem is not solved please contact our maintenance support department: (800) 992-3833.