BN Products BNT-25X, Operating Instructions Manual

Page: 4 / 12

Page | 4
Ties Per Charge 4000-5000 ties per charge
Additional Charger (BNTLI-18C)
Holster (BNH-40)
Extension Arm (BNEX-40)
Electronic Extension Arm ( *** )
Humidity 80% RH or less
Wire Technical Parameters
Part No. BNT-40-Wire
Diameter (in.) ø 0.03 (21 Gauge)
Material Q195 Galvanized
Length (in.) 3937 (approx)
Part No. BNT-40-Wire-USA
Diameter (in.) ø 0.03 (21 Gauge)
Material Q195 Galvanized
Length (in.) 3937 (approx)
Part No. BNT-40-Wire-P
Diameter (in.) ø 0.03 (21 Gauge)
Material Q195 Polycoated
Length (in.) 3937 (approx)
Battery and Charger Usage
Before inserting or removing the battery from this tool,
please set the main switch to the off position.
• To avoid a short circuit to the battery, always use the
battery terminal cover when it is not in use with the
tool.
• When placing the battery into the tool, press the bat-
tery lock before placing it into the battery holder. When
removing the battery, press the battery lock button
before pulling it out of the battery holder.
• Use 100-240V ~ 50-69Hz AC power supply for the
charger. Fully insert the battery into the charger slot
and it will begin to charge automatically as indicated
by the charging light. It will take approximately 74
minutes to fully complete the battery charge.
• It is recommended to charge the battery between 32°F
and 113°F. Do not charge in extreme cold or hot envi-
ronments.
Machine Operation and Methods
Before inserting and removing the wire spool turn the
main power switch to the off position, lock the trigger
switch and remove the battery.
When installing the wire coil spool.
only use recommended wire
without rust in this tool.
Only use recommended wire spools. Using non-standard
wire or spool could cause the tool to malfunction.
• Cut about 2 inches of wire from the coil.
• Push the reel stopper to release the reel stay and open
the gate at the same time.
• Install the wire pool with the left side facing the tool.
Lock the opening by closing the reel holder door.
• Insert the wire into the wire guide “C” (Note: the wire
must not be bent or curved).
• The wire must pass through the wire guide “C” in be-
tween the two feeding gears until it reaches the flared
tub. Then push the wire an additional 1/2” into the
flared tub.
• Keep pushing the wire until it reaches the arm “A” unit.
• Release the release stopper and confirm the release
lever has returned to its original position. (Note: the
wire must be clamped by the feeding gears).
• Remove the rest of the remaining adhesive tape from
the wire spool if any.
• Install the battery into the machine, when you hear
a locking sound the battery has been installed cor-
rectly. (Note: make sure that the main power switch is
in the off position and that the trigger is locked before
installing the battery).
• Turn on the main power switch. The machine is now
ready for use.
How to remove the wire coil spool
• Turn off the main power switch, lock the trigger and
remove the battery.
• Press the release lever and confirm that it is caught in
the open position.
• Remove the plastic wire spool.