Page | 6
•
Refer to Figures to install wheels as shown.
•
Slide the axle through the frame brackets.
•
Slide on the wheel and flat washer, then assemble
flange nuts.
•
Refer to Figure to install the bracket as shown.
•
Insert an M8 bolt through the bracket. Secure the
bolt with an M8 flange nut.
•
Insert an M8 bolt through the bracket. Secure the
bolt with an M8 flange nut.
SECTION 3 - FEATURES AND CONTROLS
Read this Operator’s Manual and safety rules before
operating your generator. Compare the illustrations
with your generator to familiarize yourself with the lo-
cations of various controls and adjustments. Save this
manual for future reference.
Parts of Generators
1- CHOKE LEVER
10 - 120 VOLT AC, 30
Amp TWIST LOCK
RECEPTACLE
2 - AIR CLEANER
11 - VOLTMETER
3 - RECOIL STARTER
12 - AC CIRCUIT
BREAKER
4 - ENGINE SWITCH
13 - 120V, 20Amp GFCI
DUPLEX RECEPTACLE
5 - OIL DRAIN BOLT
14 - ROLL OVER VALVE
6 - OIL DIPSTICK
15 - WHEEL
7 - BATTERY
16 - CARBON CANISTER
8 - 120/240 VOLT AC,
30 Amp TWIST LOCK
RECEPTACLE
17 - FUEL TANK CAP
9 - GROUND TERMI-
NAL
18 - FUEL GAUGE
NOTICE -
Pictures and drawings used in this manual
are for reference only and do not represent any specific
model.
SECTION 4 - PREPARATION BEFORE
OPERATION
4.1 - ADDING ENGINE OIL
All oil should meet minimum American Petroleum Insti-
tute (API) Service Class SJ, SL or better. Use no special
additives. Select the oil’s Viscosity grade according to
the expected operating temperature.
•
Above 40°F, use SAE 30
•
Below 40°F and down to 10°F, use 10W-30
•
Below 1°F, use synthetic 5W-30
NOTICE -
Improper treatment of generator could dam-
age it and shorten its life. DO NOT attempt to crank
or start the engine before it has been properly serviced
with the recommended oil. This could result in an en-
gine failure.
Summary of Contents for BNG2000
Page 16: ...Page 16 ...
