DBD-16X Bender Manual | Page 2
NOTE: When using electric tools, basic safety precautions should always be followed to
reduce the risk of electric shock and personal injury, including the followings items:
READ ALL INSTRUCTIONS AND SAVE THEM FOR FURTURE REFERENCE
1.
Keep hands away. From all moving parts and rollers while operating.
2. Dress properly. Loose clothing or jewelry can get caught in moving parts. Wear sturdy boots with
non-skid soles. Steel toed boots and safety glasses are recommended.
3. Keep children and bystanders away. Distractions can cause you to lose control.
4. Do not overreach. Keep proper footing and balance at all times. This enables better control of the
power tool in unexpected situations.
5. Stay alert. Watch what you are doing and use common sense when operating a power tool. Do not
use a power tool while you are tired or under the influence of drugs or alcohol. A moment of inat-
tention while operating power tools may result in serious personal injury.
6.
Do not exceed the maximum number of bars that can be bent at one time. Please refer to specifica-
tions on page 3 -4.
7.
When positioning the bar between rollers, make sure to lay it flat on the machine surface. Failure to
do so may cause the rebar to fly out.
8. Do not expose tool to rain or use in damp locations.. Do not use tool in presence of flammable liq-
uids or gases. Keep work area well lit. If the tool is used outdoors, keep it covered when not in use
and protect it from rain or water.
9.
Do not try to bend materials harder than “Grade 60 or 600N/mm2” as they will either crack and fly
out or cause machine failure.
10.
Disconnect tool from receptacle when not in use. Disconnect when servicing or changing rollers to
prevent accidents.
11.
Keep tool clean at all times for best and safest performance. Follow instructions for lubricating and
changing parts. Keep hands dry and free of oil or grease. Inspect switches, tool cords periodically
and have them repaired or replaced by an authorized service center if damaged. Check moving
parts for alignment and binding as well as for breakage and improper mounting. Damaged parts
should be repaired or replaced by an authorized service facility unless otherwise indicated in this
instruction book.
READ ALL INSTRUCTIONS AND SAVE THEM FOR FUTURE REFERENCE
