BMW S 1000XR 2018, Rider'S Manual

Page: 100 / 241

Individualizing LAPTIMER
Activate standard display
(
105).
The odometer (
ODO
) is dis-
played.
Briefly press INFO
2 .
The LAPTIMER is opened and
shows
RUN
3 and
BESTLAP
4
in the factory setting.
To change content of lines
3
and 4 in LAPTIMER, repeat-
edly press and hold INFO 2
until lines 3 and 4 are dis-
played as desired.
The desired LAPTIMER display
structure is adopted and saved.
LAPTIMER display structure
(
107)
Starting time recording
Requirement
The LAPTIMER is opened.
Press button 1 to start record-
ing.
NOTICE
For the headlight flasher signal
to be detected, the engine must
be running and the motorcycle
moving.
Time recording
RUN
2 is run-
ning.
When driving over Start/Finish
line, press button
1 again to
start recording for next race
lap.
The data of the preceding race
lap will be saved.
RUN
2 restarts at
00:00:00
.
If the display mode is exited
during a recording, then the
recording continues to run.
However, the recording of a
new lap can only be started in
the other modes with an exter-
nal signal.
Infrared receiver
The LAPTIMER can be conve-
niently operated with an infrared
signal. On this, the following
should be noted:
The infrared receiver available
as an optional accessory must
be connected to the connector
for optional accessories under
7
98
z On the racetrack