BMW 2011 R 1200 GS, Rider'S Manual, Page: 108 / 167

are programmed into the control
unit and are fundamental to all
calculations. Any change in these
influencing variables, caused for
example by a switch to wheels
other than those installed ex-
works, can have serious effects
on the performance of the con-
trol systems.
The sensor rings are essential
for correct road-speed calcula-
tion, and they too must match
the motorcycle's control sys-
tems and consequently cannot
be changed.
If you decide that you would like
to fit non-standard wheels to
your motorcycle, it is very im-
portant to consult a specialist
workshop beforehand, prefer-
ably an authorised BMW Motor-
rad dealer. In some cases, the
data programmed into the control
units can be changed to suit the
new wheel sizes. RDC label
with tyre pressure monitoring
(RDC)
OE
Incorrect tyre fitting can
damage the RDC sensors.
Be sure to explain to the au-
thorised BMW Motorrad dealer
or the specialist workshop that
the wheel is fitted with an RDC
sensor.
If the motorcycle is equipped
with RDC, each wheel rim bears
an adhesive label indicating the
position of the RDC sensor.
When changing the tyre, take
care not to damage the RDC
sensor. Be sure to draw the
attention of the authorised BMW
Motorrad dealer or specialist
workshop to the fact that the
wheel is fitted with an RDC
sensor.
Remove the front wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
with BMW Motorrad Integral
ABS II
OE
Unclip the two retaining clips 1
holding the ABS sensor cable
to the brake line.
8
106
z Maintenance
ProCarManuals.com