BMW 2004 645Ci, Owner'S Manual

Page: 101 / 217

Practical interi
or
acc
ess
orie
s
100
Practical interior accessories
Integrated universal remote
control*
The concept
The integrated universal remote control
replaces up to three different hand-held trans-
mitters for various items of radio-controlled
equipment such as door openers and house
alarm systems. The integrated universal remote
control registers and stores signals from the
original hand-held transmitters.
The signal of an original hand-held transmitter
can be programmed into one of the three mem-
ory buttons
1 . Then the respective device can
be actuated using the memory button
1
pro-
grammed for its use when the ignition key is in
position 2. The LED
2 flashes to confirm trans-
mission of the signal.
If you sell your vehicle one day, delete the saved
programs beforehand for your own security,
refer to page
101 .
To prevent possible damage or injury,
before programming or using the inte-
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the travel
range of the device. Also comply with the safety
precautions of the original hand-held transmit-
ter.
<
Checking compatibility
If you see this symbol on the packaging
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to
assume that it is compatible with the integrated
universal remote control.
If you have additional questions, please consult
your BMW center or call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark owned by
Johnson Controls, Inc.
Programming
1 Memory buttons
2 LED
Fixed-code hand-held transmitters
1. Ignition key in position 2.
2. When using for the first time: press both
outer buttons
1 for approx. 20 seconds,
maintaining pressure until the LED 2 starts
to flash. The three memory buttons 1 are
cleared.
3. Hold the original hand-held transmitter at a
distance of approx. 2 in/5 cm to 8 in/20 cm
to the memory buttons
1
.
The required distance between the
hand-held transmitter and the mem-
ory buttons 1 depends on the respective
system of the original hand-held transmitter
used.
<
4. Simultaneously press the transmit button
on the original hand-held transmitter and
the desired memory button
1 on the inte-
grated universal remote control. Initially, the
LED
2 flashes slowly. Release both buttons
as soon as the LED 2 flashes rapidly. If the
LED 2 does not flash rapidly after approx.
15 seconds, change the distance.
5. To program other original hand-held trans-
mitters, repeat steps 3 and 4.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.