BMW Motorrad S 1000XR 2020, Rider'S Manual

Page: 170 / 259

Replacing the LED light
source
WARNING
Overlooking the vehicle in
traffic due to a defective light
source on the vehicle
Safety risk
Replace defective light sources
as quickly as possible. For de-
tails please contact a special-
ist service facility, preferably
an authorized BMW Motorrad
Retailer.
All light sources on the vehicle
are LED light sources. The
service life of the LED light
sources is longer than the
assumed service life of the
vehicle. If an LED light source
is faulty, please contact a
specialist workshop, preferably
an authorized BMW Motorrad
retailer.
Jump-starting
CAUTION
Touching live parts of the ig-
nition system when the en-
gine is running
Electrocution
Do not touch parts of the igni-
tion system when the engine is
running.
ATTENTION
Current too high when jump-
starting the motorcycle
Cable fire or damage to the mo-
torcycle electronics
Do not jump-start the motor-
cycle using the power socket,
only via the battery terminal.
ATTENTION
Contact between crocodile
clips of jump leads and mo-
torcycle
Danger of short circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
higher than 12 V
Damage to the motorcycle's
electronics
The battery of the donor vehi-
cle must not exceed a voltage
of 12 V.
Do not disconnect battery from
onboard electrical system for
jump-starting procedure.
Removing seat (
83).
Run the engine of the donor
vehicle during jump-starting.
Begin by clamping one end
of the red jumper cable to the
positive terminal of the drained
battery and clamping the other
9
168
z Maintenance