D1 series
2-2
Assemble Steps
2-2-1
Set Condenser (Figure 4/5)
Set condenser for normal illumination
1.Turn the coarse knob with the direction showed to
make the stage to highest position. (Figure 4)
2. Turn the condenser knob with the direction showed
to make the condenser holder down to suitable
position.
3. Loose the lock screw for condenser thoroughly.
4. Slide the condenser into holder with the direction
showed till it is tied with the holder. And turn the
condenser to make the knob direct to front.
5. Tight the lock screw and use knob moving the
condenser up to highest position.
Set condenser for Kohler illumination
1.Turn the coarse knob with the direction showed to
make the stage to highest position. (Figure 5)
2. Turn the condenser knob with the direction showed
to make the condenser holder down to suitable
position.
3. Loose the lock screw for condenser thoroughly.
4. Put the screw behind condenser matching with the
slot on condenser holder and slide it into
thoroughly.
5. Tight the lock screw and use knob moving the
condenser up to highest position.
2-2-2
Assemble objectives
（
Figure 6
）
1. Turn the coarse knob
①
with the direction showed
to make the stage to suitable position. (Figure 6)
2. Assemble the objectives from low to high
magnification clockwise.
Please use objective with low magnification
(such as 4X or 10X) to find the image.
Please make sure correct position with a sound
during turning the nosepiece.
4
图
3
图
14
135
图
4
图
4
图
4
Figure 5
Figure 4
Figure 6
