7
USING TRAILSAFEBT
Correct operation of
TrailSafeBT
should be checked prior to each use of the trailer.
This check should be done prior to the trailer being hitched to the towing vehicle.
TrailSafeBT
can be checked by removing the Pull Pin. This will activate the system
and illuminate the LED according to the table below.
LED Colour Status
RED
1 Flash
Pull pin is not in a good condition
>
System may not be able to provide emergency braking
RED
2 Flash
Battery not detected
>
System will not be able to provide emergency braking
ORANGE
Flashing
Status being determined
>
Wait or check battery manually
ORANGE
Lead Acid Battery - Battery may not be suitable for 15 minutes
of operation
>
Turn off all loads on the house battery
>
Check battery condition and charge battery if possible
LiFePO
4
Battery - Battery is not OK for 15 minutes of operation
>
Charge battery before travel
>
Ensure a Green LED is present before travel
GREEN
Lead Acid Battery - Battery suitable for
>
15 minutes of operation
(only displayed on Brake Application)
LiFePO
4
Battery -Battery suitable for
>
15 minutes of operation
(only displayed on Brake Application) but it is recommended that all
non-essential loads are turned off prior to travel
BLUE
Flashing
System Initialisation
>
Wait or check battery manually
>
Do not remove Pull Pin
Summary of Contents for optional TrailCheck
Page 1: ... optionalTrailCheck OWNER SMANUAL TrailSafeBT teambmpro com ...
Page 2: ......
Page 15: ......
