9
SWAYCONTROL WIRING HARNESS
The SwayControl wire harness has five wires requiring electrical connection and
one cable for the status LED light.
When making connections to the caravan/trailer’s wiring harness, the
desired termination is a solder joint. If the connection is not soldered, use
the appropriate size and type of “crimp-type” weather sealed heat-shrink
connectors, using the manufacturer’s recommended crimping tools in
accordance with their crimping instructions.
SwayControl
Wire
Trailer Wire Function
Required Wire
Size (Minimum)
PURPLE
Left side electric brake output (all left side brakes)
1.8mm2
PINK
Right side electric brake output (all right side
brakes)
1.8mm2
WHITE
Trailer battery/frame ground point
1.8mm2
BLUE
Electric brake controller signal from tow vehicle
1.8mm2
BLACK
12V DC from tow vehicle trailer harness
1.8mm2
Table 1:
SwayControl wire harness electrical connections and required wire gauge.
WIRING INSTRUCTIONS
WARNING
Taking shortcuts when connecting any wires on your caravan/trailer only increases
the likelihood that some part of your electrical system will fail.
Make sure connections are durable and sealed against exposure to weather and
corrosive elements. One loose connection can disable your entire caravan/trailer
brake system.
WARNING
Failure to use the correct wire may result in poor braking performance or brake
failure. Incorrect wire size may also result in significant damage to your caravan/
trailer or its components.
Undersized wire will prevent electrical circuit protection devices such as fuses or
circuit breakers from functioning properly.
Summary of Contents for 033362
Page 1: ...TEAMBMPRO COM OWNER S MANUAL SwayControl ...
Page 2: ......
Page 5: ......
Page 10: ...10 WIRING DIAGRAM ...