AMS-K
Page 2
1
Application-specific data
5B measuring module ____________________
•
Type:
•
Measured phys. quantity:
•
Amplification:
•
Filter cut-off frequency f
g
:
•
Other:
Assignment AMS-______________
Input socket
5B module
-SE
-EXC
LO
0EXC
HI
+EXC
+SE
2
Assembly
Mounting of the 5B modules to the cassette and into the
AMS device is done in a few simple steps.
2.1
5B module
As the cassettes are already pre-assembled only mount
the relevant 5B module and fix it on the cassette using
the screw of the 5B module and the included flat nut.
2.2
Mounting in the AMS amplifier system
Insert the cassette board along the guide bars of the rele-
vant slot into the AMS housing in upright position until
the pins of the 5B module and the 7-pole pin connector
(P1) are plugged in the corresponding connectors of the
AMS carrier board. Now press the cassette with the right
touch in the backplane the front panel touching the
housing frame.
The cassette is screwed to the housing at both ends of
the front panel for a save installation. To better distin-
guish the input signals from each other, the inscription
fields on the panels can be used.
Mounting of the cassette must only be done with slight pressure to connect the pin plug with the car-
rier board! If the resistance is too high, check if the cassette is in the guide bar or if the pins are bent.
Too much pressure may damage the 5B module, the cassette, or the AMS device!
