Polymate
®
YH-1000C Polysomnograph User Manual V3.1
12
Figure 3 Fixed positions of body position sensor and snore sensor
z
To Apply the SpO
2
Sensor
Contact the nail cover with flashing red light, the signal receiver attached to the other side of the
finger opposite the red light. Observe SpO
2
and pulse rate value on the LCD screen, if fixed
correctly, about 10 seconds later, the patient's current value of SpO
2
and pulse rate will be shown.
Then fix sensor with plaster, as shown in Figure 4. In order not to affect the patient's action, it is
suggested that the sensor fixed on the patient's
forefinger , at the same time the sensor cable
should be set aside a certain amount of scope, and fixed well in the hand and wrist.
NOTE: When the SpO
2
sensor probe is to be removed from patients and cleaned-up, be careful
not to directly pull cable, which will have an impact on sensor life.
The performance of the SpO
2
sensor probe is compromised by motion; use of SpO
2
sensor probe
is contraindicated for active patients.
The SpO2 Sensor model is S0044D-S.
Figure 4 Fixed Position of SpO
2
Sensor