GETTING STARTED
1.
Once the printer is switched ON, the RED LED will blink a few times
while configuring the Bluetooth Baud Rate and default parameters of
the Printer. Please wait for this process to be completed before using
the Device.
2.
If the Printer is not getting switched ON:
a.
Check if the Battery is properly inserted.
b.
Connect the charger to charge the Battery
c.
Press MODE Button continuously for 1-2 Sec to get test print
3.
In case print is very light even after connecting the charger, either
battery is faulty, or it is not connected properly to the battery
connector.
4.
Mode Button shows following important information:
a.
Bluetooth Name
(e.g.BTprinter1234), which will show on your
Bluetooth Phone / tab / laptop.
b.
Battery Status
to see how much charge the battery has. In case
of low battery, please charge the device for 3 hours before use.
c.
Firmware version
d.
Communication:
this shows Bluetooth/USB if both modes are
working properly. It will not show the mode(s) that is/are not
working.
5.
Bluetooth Passwords for pairing (if required): 1234 / 0000