31
BA-077/1EN M6X.20XX
4 - Working with PRO-CENTER
4.3.1) General
a) Storing drilling heads
• Attach drilling head holder to a wall, table or the storage rack
4.3 - Drilling heads overview
b) Setting drill bit length
Important
The total length of the drill bits (from bit-tip to adjustment screw) must
be
- Vertical gearbox
X=57 mm
- Horizontal gearbox
X=77 mm
Adjustment
• Set length by turning the drill bit adjustment screw using a screwdriver.
c) Inserting drill bits into the chuck
Attention
Before changing drill bits, remove the drilling head from the machine.
• Loosen the fixing screw using a hex wrench
• Insert drill bits into the chuck
(The flat surface of the drill shaft must be placed in the direction of the fixing screw)
• Retighten fixing screw
Important
Insert cover caps into the unused chucks. This will keep the bits clean
and prevent the fixing screws from coming out on their own.
d) Attaching insertion ram to the swing arm
• Place insertion ram onto the two fixing screws
(A)
on the swing arm
• Tighten the fixing screws
(A)
so that the insertion ram is secure
Setting insertion ram position
• Loosen fixing screws
(A)
• Correct the position of the insertion ram by setting the adjustment screws
(B)
• Retighten fixing screws
(A)
!
!
