28
V1.1
SmartBus P900-TI6N USER MANUAL
L
E
D
Depending on your needs, your installer can program your control panel to recognize and control
2 separate areas (Partition 1 and Partition 2) by activating the system’s partitioning feature. User
codes can also be programmed to ARM/DISARM one partition or both partitions simultaneously.
You can use partitioning in installations where shared systems are more practical, such as
office/warehouse buildings, or apartment/condominium complexes.
Zones can be divided into two systems. Based on your requirements, the installer designates
which zones belong to Partition 1 and Partition 2, both partitions (dual area), or are not given any
partition assignment. A zone belonging to a 2 partitions is armed only when both Partition 1 and
Partition 2 are armed. However, this sharing zone will be disarmed if either Partition 1 or Partition
2 is disarmed.
The installer must program the required user code settings. These settings determine which user
codes can arm Partition 1, as well as which user codes can arm Partition 2. Codes can also be
given access to both partitions.
If your user code has access to both partitions
[
] + [USER CODE] + [#] + [1] + [2]
(Leave via ENTRY/EXIT Zone)
1. Ensure that all zone indicators are distinguished; if not, check that all protected premises
are closed.
2. Press
[
]
key to cancel any unintended entries.
3. Enter a valid 4-digit
[USER CODE]
. If you enter mistakes, press
[
]
key and re-enter the
code
followed by
[#]
key to confirm your command.
4. If the key in user code is assigned to control 2 partitions, zone indicators 1 and 2 will
flash.
5. Press key
[1]
followed by key
[2].
6. The
P1
and
P2
indicators will illuminate.
8.13 PARTITIONING THE SYSTEM
8.14 ARMING A PARTITIONED SYSTEM
8.14.1 AWAY ARMING 2 PARTITIONS SIMULTANEOUSLY
