S D S 2 0 0 P I P E D R A I N C L E A N E R
4
Operations
Note
THOROUGHLY READ THROUGH THE ENTIRE MANUAL BEFORE OPERATING THIS MACHINE!
PURPOSE
Ø
The purpose of the SDS200 is for cleaning the insides of drainpipes from 2” to 8” in diameter. This is a
heavy-duty professional use machine allowing a single user to easily clean pipes.
Ø
This type of sectional drain cleaner uses individually lengths (sections) of cleaning cable. This machine
uses 16’ sections, which can be added or subtracted during cleaning operations.
o
Maximum length of any particular run should be 165’ (50M).
MACHINE SET-UP
Ø
The machine is designed pre-assembled. The user must only take the item out of the shipping crate.
o
CAUTION: This machine is heavy lifting should be avoided whenever possible.
o
DO NOT allow the cord or plug to drag along the floor when wheeling between locations.
Ø
Make certain the work area is dry.
o
DO NOT place the machine in water.
Ø
Use barriers to keep non-essential personal away from rotating drain cable or other moving parts.
Ø
Place machine away from passageways and make certain the operator is able to see all parts of the work-
piece.
Ø
DO NOT set-up or modify the machine in a manner that is not intended.
Ø
DO use a user provided functioning GFCI circuit when using this machine.
MACHINE COMPONENTS
Ø
The main components of the SDS200 are motor housing, rotating clutch channel and main machine frame
assembly (see figure below). The motor drives the clutch rotationally and acts as the main drive
component of the machine.
o
These components must be not be removed except by a qualified technician. Power must be
disconnected prior to any service.
Chapter
3
