BlueParrott C300-XT User Manual
PAGE 18
ADVANCED FEATURES AND FUNCTIONS
(continued)
Muting
By default, the Parrott Button will act as a mute on calls (unless it has been configured for
another function) . The Volume Up button will also function to control mute .
• Unless otherwise configured, pressing the Parrott Button while on a call will mute the
headset . Press again to unmute . Mute and unmute is indicated by a beep .
• To use Volume Up to mute the headset microphone while on a call, press and hold the
Volume Up button for 1-2 seconds . To unmute, press and hold the button again for 1-2
seconds .
• While muted, a reminder tone will sound every 10 seconds .
Transferring Audio
To transfer audio from the headset to the cell phone while on a call, press and hold the
Volume Down button for 1-2 seconds . The audio will transfer to the phone . Repeat to
transfer audio back to the headset . When audio is transferred to the phone, the LED on the
headset will be off until audio is transferred back to the headset .
Turning Headset Indicator Lights On/Off
Simultaneously pressing the Volume Up and Volume Down buttons together will turn the
headset indicator LEDs off . Repeat to turn the indicator LEDs on .
When powering on the headset, the indicator LEDs will be in the same state as they were
when last powered off .
Reset Headset Paired Devices List
This will reset, or clear the headset’s internal paired devices list . The headset must be on to
perform this function .
1 . Power on the headset . It does not matter if it connects to any devices .
2 . Hold the headset near your ear and press and hold the Volume Up and the Volume Down
buttons together for approximately 6-10 seconds until two low tones sound .
3 . Power off the headset . The pairing memory is now clear and the headset will need to be
paired to any desired devices before it can be used with them .
Reset Parrott Button Defaults
This will reset or clear the headset’s internal paired devices list and will also restore the
Parrott Button’s factory defaults (voice command and mute) . The headset must be on to
perform this function .
1 . Power on the headset . It does not matter if it connects to any devices .
2 . Press and hold the Parrott Button and the Volume Down buttons together for
approximately 6-10 seconds until you see two quick purple flashes on the MFB .
3 . The headset Parrott Button is reset and the pairing memory is now clear . The headset will
re-enter pairing mode . If you are not ready to re-pair to your device, power off the headset .
