BlueParrott C300-XT User Manual
PAGE 12
Manual Pairing
If the C300-XT has already been paired with another device and you are not going to
use NFC Pairing, you will need to put it into Pairing Mode manually:
Placing Headset in Pairing Mode
By Voice:
Activate headset voice recognition by pressing the Parrott Button or by pressing and
holding the Volume Up button . Then, after the prompt, say “pair mode .” The headset
will enter Pairing Mode and be visible for pairing to devices for 120 seconds .
Using Buttons:
With the headset powered off, press the MFB until the LED rapidly flashes blue and
you hear the audio prompt “power on .”
Keep holding
the MFB for approximately 10
seconds until you hear “Pair Mode” . The LED will rapidly flash blue and red when in
Pairing Mode, and will be visible for pairing to devices for 120 seconds .
Pairing to a Cell Phone
1 . Make sure that other Bluetooth devices are turned off or out of range .
2 . Place the headset into Pairing Mode .
3 . Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer’s
instructions .
4 . Select “BP C300-XT” to pair . (Passcode is “0000” if needed .)
5 . Accept the phone book access request to enable caller ID in the headset .
6 . When connected, the headset will give you the voice prompt, “Your headset is
connected .”
GETTING STARTED
(continued)