4
Safety
1. Read carefully before usage.
2. The Calcium Reactor is only suitable for indoor use.
3. Ensure voltage shown on the label match to the mains supply voltage.
4. Ensure that water cannot reach the socket.
5. Never let the pump run dry, damaged caused by dry running
is not covered under warranty!
6. Disconnect reactor from mains before any maintenance on your aquarium.
7. If damaged the supply cord cannot be replaced, the whole pump needs to
be replaced.
8. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Special care should be taken
with the use of electrical equipment by or near children.
Installation
1. Remove the 4 nylon screws on the cover of the media chamber.
2. Add media.
3. Check if the rubber seal ring is correctly placed on top of the media chamber.
4. Put the cover back in place, ensure the seal ring stays in place, close lid with the
nylon screws.
5. Connect the pump (4) to both pipes, please close the connections hand-tight if the
unit leaks close them a bit tighter.
6. The calcium reactor needs water supply from either your sump or aquarium, this
can be done in 2 ways. Please see below for water feeding instructions.
7. Once you have connected the water supply fill the calcium reactor completely with
water and check for any leakage, solve leakage if any.
8. Now turn the pump on and check again for any leakage.
9. Now turn on the Co2 supply.
Water supply
Pressure feed:
Water intake directly from aquarium or sump via a suitable power
head ( we advise the Superfish Aqua power 200, return water goes directly back to
the aquarium / sump. This allows a remote positioning of the unit at any height above
aquarium or sump. Ensure that connections and hoses from the power head to the unit
are suitable for the pressure developed by the feed pump and if necessary fit a bypass
to reduce the pressure.
Gravity feed:
The unit can be operated siphon fed from your tank to the calcium
reactor and then straight into the sump. This way there’s no need for an external pump.
Gravity feed connector included
GB
Instruction Manual
