12
Cleaning and Maintenance
TROUBLESHOOTING
•
The pump should be inspected 3-4 times per year for pump movement or buildup of
debris on the switch or float. Reposition pump if it has moved. Remove any debris that
could interfere with the operation of the switch. Lack of proper routine maintenance
will void warranty.
•
Make sure the pump is plugged in to a working ground fault circuit interrupter (GFCI)
outlet and the cord is in good shape. In damp areas, GFCI breakers may trip,
effectively shutting off the sump pump. Check in on your sump pump and reset the
GFCI if necessary.
•
Ensure the pump itself is standing upright. Vibrations during operation can cause it to
fall or tilt onto one side. This can jam the float arm so it can’t activate the pump.
Do not disassemble the motor housing. This motor has NO repairable internal parts, and
disassembling may cause an oil leak or dangerous electrical wiring issues.
•
WARNING
Possible Cause
Problem
Corrective Action
Pump does
not start or
run
The pump
will not
prime or
retain prime
after
operating
1. Blown fuse
2. Tripped breaker.
3. Plug disconnected.
4. Corroded plug.
5. Thermal overload.
6. Motor failed.
7. Float switch obstructed.
8. Float switch failed.
1. Replace fuse.
2. Reset breaker.
3. Secure plug.
4. Clean plug prongs.
5. Unplug for 30 minutes, then plug in.
6. Make sure the float switch has room
to move and is not getting caught
on anything. Make sure your pit is at
least 14 in. wide.
7. Purchase a replacement float switch.
1. Clean screen.
2. Reassemble impeller.
1. Screen blocked.
2. Impeller loose on shaft.
3. Impeller broken.
