4
Testing:
Test the light before installation ensuring that you use the correct voltage and the light is illuminated
correctly.
After installation ensure again that the light is illuminated correctly before the boat goes back into
the water and you remove the lens label.
After you boat goes back into the water check internally for water tightness around where the light is
installed.
The light has internal indicator Led’s for fault finding, these are as follows:
Over temperature will show RED.(allow the light to cool down and check if submerged)
Maintenance:
Regularly check the installation for water tightness
Only clean the light with a soft bristle brush
Warranty:
Your product has a 2 year limited warranty for defects.
For any warranty issues please contact your point of sale retailer or go to
www.bluefinled.com
for
further advice.
Do not attempt to disassemble the light without BluefinLED advice.
Installer please ensure that the SERIAL NUMBERS of the lights are written below and the
manual is handed over to the end user.
Please make a note of the serial numbers of the lights here.
SERIAL NUMBERS
Bluefin
LED
Cottage Farm, Cottage Lane,
Norton Juxta Twycross, Atherstone. CV9 3QH
Sales - Tel: 07950 909048
Email:
Service - Tel: 01827 880450 Email:
Administration - Tel: 01827 880450
Email:
Registered Address:
Square Rig Limited, t/a Bluefin LED, Cottage Farm, Cottage Lane, Norton Juxta Twycross, Atherstone, CV9 3QH
Company Registration Number:
08871451
VAT Number: 179 2690 64
Bluefin Led Underwater lights.
LM24CC Driver Installation manual.
Thank you for choosing Bluefin LED underwater lights, our products have been designed and tested
rigorously to ensure the optimum performance and longevity.
Please ensure that your product is installed as per our instructions below, failure to do so may
invalidate your warranty.
Specs: electrical/fuse ratings
Voltage
Current
Fuse rating
LM24CC Drivers
12/24V only
12V-5A 24V-2.6A
8amp
Warnings:
Summary of Contents for Mako M12IFM12V
Page 8: ...8...