Bluefin LED Mako M12IFM12V, Installation Manual, Page: 3 / 8

3
Fig 4
Fig 5
Bluefin LED Underwater lights. YOU MUST INSTALL THIS GEL CONNECTOR OR
YOUR WARRANTY WILL BE VOID !!!
Please ensure that your product is installed as per our instructions below, failure to do so WILL
INVALIDATE YOUR WARRANTY.
Use these instructions in conjunction with the light instructions to ensure that all is fitted correctly.
Warnings:

Do not attempt to install the lights whilst the boat is in the water.
Installation:
Fig 1 showing how the Gel connector is wired up.
Fig 2 showing how the finished Gel connector should look when finished.
Ensure that the black outer sheath is inside the gel connector.
The IP68 GEL CONNECTOR MUST BE INSTALLED CORRECTLY OR YOU WARRANTY WILL BE VOID.
Fig 1
Fig 2
Positive wire
from Light
Heatshrink for
water tight seal to
the fuse holder
Fuse holder
Crimps for
positive wires
(ensure that these
are mounted into
the holder before
they are crimped)
Picture showing
example of
clamping ring and
washer
assembled
Image showing how to
wire the Gel Connector to
the light and Fuse holder
Please use fuse
instructions within
the manual to wire
the fuse
Power
In
from
boat
power
Light
cable
Negative wire
to boat power
in
Heatshrink