24
English
The transmission signal is encrypted and encoded to prevent other electronic devices from being affected by
the transmitter. The draught in the chimney is regulated either automatically with the built-in program or
manually, if needed. The device will switch off automatically approximately 4 hours after the last key press.
The remote control works both with a fully automated program and with manual
control.
Fully automated transmitter operation:
On start-up/relighting, the Start/Boost
O
is activated by pressing before lighting in
the fireplace.
First 20 minutes:
BlueChimney starts by boosting the draught for 20 minutes to prevent smoke from
going into the room during lighting. The speed is subsequently reduced by half
automatically.
Next 100 minutes (1 hour and 40 minutes):
BlueChimney runs at half speed so the wood-burning stove burns most
economically and pollutes as little as possible.
After two hours more:
BlueChimney switches off automatically.
Relighting the fire:
Push the “Start/Boost”
O
button again before relighting the fire/adding wood to avoid smoke. This way the
automatic system will start a new burning sequence of a total of 4 hours.
Manual operation:
Automatic operation can be cancelled at any time, and exhaust can be regulated by
pushing “more draught”
, “less draught”
or the “Off” button”
The BlueChimney switches off automatically 4 hours after you last push a button.
Extended program functions
BlueChimney can run continuously
if
— 15 seconds after the latest push of a button — you press
and then, between 2 and 8 seconds later, you press the “more draught” button
.
the button “Off”
BlueChimney will then start at its highest speed, which can subsequently be adjusted to the desired draught
using the same arrow up and arrow down keys. Press the “Off” button to switch BlueChimney off, which will
then go back to normal program the next time BlueChimney is started.
Battery replacement in the remote:
Press with a pointed object into the little hole in the back of the remote, and then loosen the control panel.
Pull out the black plastic holder and then insert 2 new batteries
— CR 2016 — and press the control panel into
place.
