IMPORTANT
Safety instructions
PRE-INSTALLATION
Before you begin
To access the wiring terminal, open the enclosure by
removing the four screws with the provided 3/16” hex
key. The meter must be powered by 5 volts DC. Wattage
must not exceed 5 watts. 20-24 AWG(American Wire
Guage) shielded cable is recommended for signal output
connections.
The MS6 wiring compartment is equipped with two
communications cable liquid-tight cable glad grommets for
cable diameters from .190 to .205 inches. Refer to page 21,
section 11 of the provided Operating Manual for details.
Planning
Mounts and supports must be sturdy enough to support the
plumbing and prevent vibration. Vibration and heavy loads
will damage the meter.
Wiring
In the Box
• MS6 Chemical feed flow meter
• Meter Body Connection Fittings
• 3/16” Hex Key
• Flash Drive(Operating Manual
and Blue-Central
®
)
• USB-A to USB-C Connector
• Power Supply(User configurable)
• Quick Start Guide
Tools Needed
1/32” Mesh strainer
Follow these instructions before installing your flow meter to avoid failure.
CAUTION
The MS6 is designed to be installed and operated by qualified personnel only.
Please note that warranty coverage does not inlcude damage due to misuse or
improper installation.
CAUTION
Always wear eye protection when installing or removing flow meters.
CAUTION
Confirm chemicals being used with MS6 flow meter are compatible with wetted
components of the flow meter.
CAUTION
Do not exceed maximum pressure. High pressure and temperature will damage
the meter.
PRESSURE
Maintenance
When the MS6 Flow meter is removed from the system
or an empty pipe condition causes the meter to dry out,
always flush the meter with water before reinstalling.
