Page 11
Used to remotely start and stop pump using a dry contact closure signal.
When activated; CLOSE = START and OPEN = STOP.
Set to NO = Remote Start / Stop is disabled
Set to Yes = Remote Start / Stop is enabled
Can be used with external foot pedal, PLC, contact closure or other similar external devices.
Default setting = No (disabled)
Step 3
Press and release DOWN arrow to change setting to ‘YES.’
To change setting back to ‘NO’ press and release UP arrow.
Step 4
After you’ve made your selection, press and release START
| STOP button. This saves your setting.
You can now modify FVS setting (see next page) or you can
exit Setup by pressing and holding START | STOP button
for a few seconds until you return to Run screen.
Running pump with Remote Start / Stop enabled, ‘REMOTE’ icon will always be visible on lower left side of screen.
Pump will display ‘STBY’ (standby) if pump is in stop mode via contact closure signal.
Please use caution in this mode, pump can
start at anytime. If you must perform maintenance to pump, press and release STOP button.
yes
0
yes
0
Step 2
Press and hold START | STOP button until ‘Remote’ icon
begins flashing.
Default setting ‘NO’ will also be visible when entering
remote start / stop setup.
Note: If ‘YES’ had been selected previously, then ‘YES’ will be
displayed on screen.
no
0
Remote
Icon
REMOTE
REMOTE
REMOTE
7.0
Set Remote Start / Stop
Step 1
Press and release STOP button
Note: Cannot enter programming mode while pump is running.
off
®
CHEM-PRO C2F/C3F
