NP5767
9
Locking the Buckle (if you have a cover)
2. Cleaning/Replacing Filter Cartridge
NOTE:
A dirty filter cartridge may contaminate the pool water and cause damage to the heating function.
NOTE:
When the filtering system has worked 150 hours accumulatively, a warning buzzer will remind
you to clean the filter, at the same time, the light of the filtering function will flash. Hold the filtering button
5 seconds to turn off the buzzer.
1. Unscrew the filter house lid by turning it counter-clockwise. Remove the cover from the filter cartridge.
2. Rinse off the filter cartridge with a garden hose. We suggest using a garden hose with our Spray Brush Head*. Once
cleaned, put the cover back on, and reuse it. If the filter cartridge remains dirty and discoloured, the filter cartridge should
be replaced. *Spray brush head can be purchased separately.
3. Screw the cleaned filter cartridge back on the pool.
Part V
Maintenance
NOTE:
Pool quality can affect your health. The filter cartridge should be cleaned every day and replaced after 7 days,
depending on use. Change water every 7 to 14 days, and use appropriate pool chemicals. Please pay attention to the
chemicals. SPA damage resulting from misuse of chemicals in the SPA water is NOT covered by the warranty.
1. Water Balance
We recommend maintaining your water balance levels at: PH value: 6.5 - 8.5; Free chlorine: 3ppm - 5ppm. Purchase a
test kit and test your water chemistry value before each use of the SPA or at least once per week.
2. Water Sanitation
We suggest using BROMINE tablets with our chemical floater (see next page) to disinfect the pool’s water (Chemical
floater should be purchased separately). Open the lid of chemical floater and put some pieces of BROMINE tablets in it.
Close the lid and put the floater into the SPA pool.
3. Cleaning the SPA
Clean the SPA pool with soap and water, then rinse thoroughly. Leave it in shady and cool place to air dry.
4. REPAIRS
(Little holes or punctures can be fixed with the repair kit included with the SPA)
A. Find the leak.
B. Thoroughly clean the area surrounding the leak. Cut a piece of repair material in a round shape larger than the
damaged area.
C. Apply adhesive (NOT included) to the underneath side of the patch and around the area to be repaired.
Coat the affected area lightly, but completely, with glue.
1
2
1.Press the sides of the top buckle together and insert into bottom buckle and move square on front to lock position.
2.To open, move lock to open poistion, and press the sides of the top buckle together and lift up.
3.Use straps to adjust tightness.