Mechanical seal, complete
Hoses and metal hose clamps
F
.
Resultant Damages
We cannot be responsible for damages to the product if the product is not used in
accordance with the instructions provided.
G
.
Technical Data and Specifications
The recommended filter run time is twice a day for 4 to 5 hours; regular backwashing
time is 2-3 minutes at least once a week, and floor vacuum cleaning as needed are
the basic pump requirement for maintaining clean swimming pool water!
The major components for all models are: (Confirm you have all these components
before starting installation)
The 7-way valve, filter pump, filter tank, 1 1/4’’-1 1/2’’ hose connectors and base
plate.
Model
NE4490 (400-HTA2SP075)
Flow rate:
5040 GPH/2160GPH
Voltage/Frequency:
115V/60Hz
Power
2 Speed 3/4 HP
Amount of Sand:
80lbs
Pool size:
12000 US Gallons
Model
NE4499 (500-HTA2SP100)
Flow rate:
5520 GPH/2200 GPH
Voltage/Frequency:
115V/60Hz
Power
2 Speed 1 HP
Amount of Sand:
150lbs
Pool size:
18000 US Gallons
H
.
Unpacking your filter system
Carefully remove the product and all component parts from the box. Cross reference all
parts in the box with the parts list reference chart to make certain all parts are present
before beginning assembly.
NOTE: Some parts may be located within the filter tank. To access these parts, you must
remove the tank cover.
Refer to *page 11&12 for complete EXPLODED VIEW PARTS DIAGRAMS.
I
.
Power source instructions
1.The Above Ground filter pump system you have purchased is equipped with a
standard electrical cord and plug which should only be connected to a power outlet
protected by a 30 Amp Ground-Fault-Circuit-Interrupter (GFCI) that has been
installed by a professional electrician and adheres to local codes and regulations.
2. To avoid electric shock, power cord extensions should not be used.
J
.
Positioning your filter system
For the operation of this filter system with Above Ground pools, you need a
skimmer installed in your pool. Either an integrated skimmer (built into the pool
wall) or a suspended skimmer (attachment to the pool wall).
The installation area must allow an adequate safety margin to the pool wall.
Page 04
