B. Hose reducer , if required
C. Hose clamp
D. Return connector
For large INTEX pools (which have swimming pool hoses with gate valves), follow the
instructions below (Fig. 3):
Connect the INTEX special adapter and the O ring with the return connector. Make
sure the O ring is in the INTEX special adapter.
Screw on the pool hose with the INTEX special adapter. Make sure that the
between the hose and the INTEX special adapter is correctly inserted.
A: INTEX special hose
B: INTEX special adapter
C: O ring
D: Return connector
E: Flat gasket
3.Correct positioning of the solar heater
Unfold the feet at the bottom and adjust position according to the sun. Make sure to obtain a
30° inclination.
The device should be assembled as shown in Fig. 4.
A: Swimming pool hose to the pool
B: Swimming pool hose from the filter / pump
C: Return connector
D: Connector flow
Make sure that all hose connections are watertight and the hose is not kinked or have any
sharp corners. If the hoses are not watertight, check whether the O rings are correctly
positioned and all connections are screwed together firmly. Do not over-tighten the hose
clamps (15kg torque).
flat
gasket
2.Connection between solar heater and pool
For pools with a Ø1.25” (Ø32mm) or Ø1.5” (Ø38mm) swimming pool hose, follow the
instructions below:
Attach the hose to the return connector on the underside of the solar heater.
Use a hose clamp to secure the hose to the return connector (see Fig. 2)
A. Pool return hose
3
