6
Service Procedures
17
©
Moffat Ltd, January 2007
Revision 1/
Blue Seal Evolution Series Gas Salamander
Figure 6.2.2b
Two
screws
Burner
guard
3) Undo the clamp on the pilot burner holding
the thermocouple in place (secured by one
screw). Withdraw the thermocouple from the
pilot assembly.
Clamp
4) Unclip the burner guard, then remove the two
screws securing the pilot bracket (inside
salamander). Withdraw the pilot burner and
bracket.
5) Fit new pilot burner to bracket, and
re-assemble in reverse order.
6) Ensure that the correct size pilot injector is
fitted to the pilot burner:
Nat
Gas 0.30mm
LPG 0.20mm
Refer to section 6.2.3 below for pilot injector
replacement.
Figure 6.2.2c
Figure 6.2.3a
Figure 6.2.3b
Pilot Screw
Cap
4) Extract the injector from the pilot burner,
taking care not to lose the spring.
5) Replace or clean the injector as necessary.
When reassembling, ensure that the injector
is fully screwed in.
Pilot
Spring
Injector
Cap
6.2.3 Pilot
injector
1) Remove the side panel (refer 6.1.2)
2) Undo the cap from the rear of the pilot burner
to give access to the injector.
3) Unscrew the pilot injector.
Figure 6.2.4a
6.2.4 Main
burner
1) Remove the side panel (refer 6.1.2).
2) Remove the burner guard by pulling it down
from the centre fastenings and then removing
it from the mounting holes in the side wall.
3) Remove the two centre fixing screws and
remove the centre bracket.
Two screws
