Blue Seal G50-8A, Installation & Operating Instructions Manual

Page: 19 / 24

D. GRIDDLE
MAIN
BURNER
To replace unscrew 3/16" screw at rear of burner and remove. Refit new
burner.
GAS
CONTROL - Servicing
To regrease gas control, remove control knobs and control panel. Remove 2
screws holding shaft plate to gas control body and remove control shaft and
plate. Note orientation of shaft for correct re-assembly.
Using needle nose pliers or similar, pull out gas control spool, again noting
orientation.
Using suitable compound rated for use with Natural and LP gases and high
temperature rating, re-grease spool.
Re-assemble by reversing procedure.
GAS
CONTROL - Replacement
1. Remove fat collection trays.
2. Remove
griddle plate.
3.
Remove knobs and control panel. Disconnect piezo H.T. lead from piezo
igniter.
4.
Remove securing nuts and washers from rear of each burner. Remove
burner(s).
5.
Unclip and remove front reflector plate from main griddle reflector panel.
6.
Slide reflector panel forward and lift away from rear.
7.
Undo pilot supply and disconnect pilot thermocouple from gas control.
8.
Using 19 mm spanner, undo compression nut securing gas control to
manifold assembly.
Re-assemble in reverse order and check for gas leaks with soapy water.
-15-
SERVICING INSTRUCTIONS