Blue Seal Evolution G570, Installation And Operation Manual

Page: 22 / 25

20
Gas Conversion and Specifications
Gas Specifications
- Non CE Only (Australia / New Zealand):
- CE Only:
Appliance Classification
Category:
II
2H3P.
Flue Type: A
1.
*
The burner operating pressure is to be measured at the target top hob manifold test point with
the target top burner (inner and outer ring) operating at full setting. The operating pressure is
ex-factory set through the appliance regulator and not to be adjusted, apart from when carrying
out gas conversion, if required. (Refer to the details in this section for information).
Nat. Gas LP Gas (Propane)
Target Top
Main Burner Injector (Inner Ring) Ø 1.70 mm Ø 1.10 mm
Main Burner Injector (Outer Ring) Ø 2.60 mm Ø 1.55 mm
Pilot Burner Injector 0.35 0.25
Burner Aeration Screw X (Inner) 25 mm 25 mm
Burner Aeration Screw Y (Outer) 28 mm 28 mm
Low Fire Adjustment 2½ turns out (ccw) 1 turn out (ccw)
Oven
Main Burner Ø 2.60 mm Ø 1.60 mm
Pilot Burner 0.35 0.23
Low Fire Screw Ø 1.5 mm Ø 0.95 mm
Burner Operating Pressure 1.00 kPa (*) 2.60 kPa (*)
Gas Regulator Cap Screw
Burner Aeration Setting Fully open Fully open
Natural Gas
(G20)
Propane
(G31)
Target Top
Main Burner Injector (Inner Ring) Ø 1.70 mm Ø 1.10 mm
Main Burner Injector (Outer Ring) Ø 2.60 mm Ø 1.55 mm
Pilot Burner Injector 0.35 0.25
Burner Aeration Screw X (Inner) 25 mm 20 mm
Burner Aeration Screw Y (Outer) 28 mm 25 mm
Low Fire Adjustment 2
1
/
2
turns out (ccw) 1
¾
turn out (ccw)
Oven
Main Burner Ø 2.60 mm Ø 1.60 mm
Pilot Burner 0.35 0.23
Low Fire Screw Ø 1.5 mm Ø 0.95 mm
Operating Pressure 9.9 mbar (*) 26.8 mbar (*)
Gas Regulator Cap Screw
Burner Aeration Setting Fully open Fully open