22
12. Refit all the trivet supports to the top of the appliance. Note
the orientation of the trivet support when re-fitting. The
trivet support front end side rail profiles are different from
the rear end side rail profiles. (See Fig 14).
13. Refit the trivets to the top of the appliance taking note that
the trivets are manufactured with a lip on one edge, the lip
must always be fitted to the outer edge (front and back) of
the cook top. (See Fig 18).
Low Fire Adjustment
a. To adjust the open burner low fire adjustment, remove
the gas control knobs from the front of the control panel.
b. Adjust the low fire adjustment screw on the open burner
gas control valves to obtain the desired flame size.
(See
Fig 19).
NOTE: The “Low Fire Screw” should be sealed with coloured
paint on completion of the low fire adjustment.
Open Burners ('PF' - Pilot & Flame Failure Option)
1.
Turn ‘OFF’ the gas supply at the main supply.
2.
Remove the trivets from the top of the appliance, taking note
that the trivets are manufactured with a lip on one edge, the
lip must always be fitted to the outer edge (front and back) of
the cook top. (See Fig 18).
3.
Remove the burner caps and burner bowls (these are a loose
fit to the manifold) from the top of the gas manifold.
4.
Remove all the trivet supports from the top of the appliance.
Note the orientation of the trivet supports when removing.
The trivet support front end side rail profiles are different from
the rear end side rail profiles. (See Fig 14).
5.
Remove the pilot burner shields from over the pilot burners /
thermocouples by removing the 2 screws securing the pilot
burner shields to the splash guards. (See Fig 21).
6.
Remove the splash guards covering the burner manifolds by
unscrewing the two allan headed screws. Carefully remove
the splash guards taking care not to damage the pilot burner
tubes and thermocouples protruding through the splash
guard.
Main Injectors
a. Unscrew and remove the main injectors (½ A/F) from the
gas cocks.
(See Fig 22).
b. Replace with the correct size injectors. Refer to the ‘Gas
Specifications' table at the end of this section and the
Rating Plate attached to the underside of the right hand
side, front oven lower trim for correct injector sizes for the
corresponding gas.
Gas Conversion and Specifications
Pilot Supply
Tube
Low Fire
Screw
Fig 19
2 Pilot Burner
Shield Screws
Main Injector
Pilot Injector
Plug
Fig 20
Fig 21
Fig 22
Pilot Burner
Shield
‘Turned Up’ lip
on Pot Stand
Fig 18
Summary of Contents for Evolution G54
Page 7: ...5 Dimensions Dimensions G54 Cook Top Options G54D Cook Top Options G54C ...
Page 33: ...31 ...
Page 34: ...32 ...