BX1975
2007-12 Dodge Caliber (No SRT)
Installation Instructions
292-2883 Rev F
Page 6 of 9
4/8/13
10. On the driver side, disconnect the horn
wire (left). Using a 10MM socket, remove
the bolt from the horn bracket (middle).
Then using a 13MM socket, remove the
bolt from the wiring harness (right).
9. On the driver side, using a 13MM socket,
remove the bolt from the wiring harness.
11. Using a reciprocating saw, trim the end of the
bumper off so that it is flush with the frame.
Do this on both sides of the vehicle.
12. Using a reciprocating saw, trim the web
3/4” up from the tab back to the frame.
Then down flush with the frame. Do this
on both sides of the vehicle.
3/4”
13. Using a 1-1/4” holesaw, drill an access
hole on the face of the frame above the
bumper. Do this on both sides of the
vehicle.