4
609 E. Pine Street Orlando, FL 32801 • Phone 888-977-8366 • Fax 407-210-6833 • www.bluworldhomelements.com
Step 2.2
Take the pump plug from the left side and insert it through the hole in the base as shown in Fig. 2.2A. We
suggest leaving some slack in the cord inside the base. Locate the Cord Strain Relief (C) in the base. Clip
the cord into the Cord Strain Relief (C) as shown in Fig. 2.2B. This will secure the cord.
Section 3 – Panel and Base Assembly
Step 3.1
Before installing the panel in the base, you must first establish the front/flow side of the unit, if not already
installed. This is easy for stone/mirror units, however, for clear glass models the front/flow side can be
easily determined by the visibility of the PVC Disperser Bar. The PVC Disperser Bar can only be seen on
the front/flow side of the panel. After you have established the front/flow side, carefully slide the panel
into the base as shown in Fig. 3.1. As noted in Step 2.1, the base should be placed with the cord exiting
the left. Note that the panel has plumbing connections on one side at the bottom. Be sure to place the
panel in the base with the plumbing connections on the right. This will allow you to connect the plumbing
from the panel to the Water Pump (A) and Water Filter / Flow Control Valve Assembly (B) that you placed
in the base in Step 2.1. Be careful not to stand the uprights on the Water Pump (A) or the cord.
Step 3.2
Once the panel is placed inside the base, turn the thumbscrews using hand-applied pressure to secure the
panel as shown in Fig. 3.2.
Step 3.3
Hand fasten the assembled Water Pump (A) and Water Filter / Flow Control Valve Assembly (B) into the
quick connect / hose coming out of the panel as shown in Fig. 3.3.
Fig 2.2 A
Fig 2.2 B
