3
609 E. Pine Street Orlando, FL 32801 • Phone 888-977-8366 • Fax 407-210-6833 • www.bluworldhomelements.com
Section 1 ‐ Initial Prepping
Your Grande fountain is fully assembled on the shipping pallet.
Step 1.1
Carefully remove all packing and wrapping. For transport to the designated installation area it may be
easier to remove the panel from the base. This will enable you to move each piece independently to avoid
any damage.
Step 1.2
Place the base in the selected area. Make certain that the area is flat, smooth, and level. The hole for the
electrical cords will be near the rear of the base. This is the back of the base for Center Mount or Rear
Mount models.
Section 2 – Pump Installation
Step 2.1
When you decide the location of the Grande it is important to place the reservoir with the plug exiting the
left side. See Step 3.1 for further information regarding this. Locate the Water Pump (A) and install the
Water Filter / Flow Valve Assembly (B) by simply threading it into the pump exhaust port as shown in Fig.
2.1A, if not already connected. Place the assembled Water Pump (A) and Water Filter / Flow Control Valve
Assembly (B) into the base as shown in Fig. 2.1B.
Fig 2.1 A
Fig 2.1 B
