10mm 3x2 Shops Middle
B10-MW-154
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B10-MW-154)
Remove the four walls and four triangular corner
bracers from the sprue. Glue the triangles to
non-etched side of the two long walls as shown
in the example above. Also attach the support to
the bottom edge of the long wall. Leave to dry.
Once the bracers are dry, apply a little glue to the side
lugs and glue the shorter walls in place as shown
above. You should now have a hollow square
structure. Leave it to dry.
Note: In the image above, the structure is upside
down, so the supports are seen at the top of the
picture.
Glue the balconies into position on the long
walls…
…and then on the short walls.