10mm Octagonal Building Middle
B10-CS-259
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
There are two different types of wall supplied
with this kit – they should alternate around the
building.
Glue two supports to the back of one of the wall
sections. Glue wall sections to each side as shown.
Note the notch will be at the top of the wall and the
tab will be at the bottom.
Repeat this pattern until you have an octagonal
structure as shown above.
Work round the building, gluing the wall coverings into
position. You may find this easier to do if you place
this building on top of the completed foyer.
The finished middle section.
