10mm Octagonal Building Foyer
B10-CS-208
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Remove two of the supports and one wall section
from the sprue as shown. Note each section has a
notch in it. This will be at the top of the wall.
Turn the wall over and glue the two supports into
position on the back of it.
Glue two more wall sections to the supports as
shown.
Then glue two more supports to one of the walls as
shown and add two more wall sections.
Take one of the supportx with a short arm and a
normal support then.…
…glue these to the end wall section, with the short
arm being at the bottom (see pic).
Repeat this on the other side so you end up with
a gap in the lower ring of supprts as shown.
Now glue the door section into place.
