10mm 3x2 Industrial Foyer
B10-CS-202
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B10-CS-202)
Remove the four wall sections and corner bracers
from the sprue as shown above.
Glue two corner bracers to the back of the two short
wall sections. Allow glue to dry.
Glue the two side walls to the end walls as shown
above.
Now remove the four decorative sections from the
sprue.
Glue these into position on the main walls using
the lines scored on the walls as a guide.
