Owner’s Guide & Installation Instructions
11 / English
Important Safety Instructions
• Make sure that shipping bolts are removed before you operate the
washer. If service is required as a result of not removing the bolts, it
will not be covered by the warranty.
• Make sure that the wash drum is empty before you load the washer.
• Do not store and use any flammable and combustible substances
such as lint, paper and chemicals near the appliance.
• Always follow the manufacturer’s instructions when you are using
a descaling agent. Be sure that descaling agent contains rust-
protective materials and rinse the washer a few times thoroughly
after the descaling process (See, Descaling the washer).
• Install and operate the washer on a solid floor to prevent vibration or
movement. It is not recommended to install and operate the washer
on wooden floor or on a carpet.
• The rated voltage of your washer is 208/240V, so it should not be
directly connected to the wall power of 110/120V. A special junction
box will be provided and used for the wall power connection
(See, Installation Instructions for Grounding Instructions and
Requirements).
• If an abnormal sound is heard during the washer operation, refer to
the “Troubleshooting” of this guide.
• Call service for checking any possible damage or fault if the
appliance is dropped or bumped.
• The end of drain hose should not contact the discharge water in
any way as this might cause siphoning of water.
• Always leave the property after checking that the wash cycle is
completed and the washer is turned off.
• Damaged or worn power cords and plugs must only be replaced by
a Blomberg Service technician.
• Never use an extension cord or adapter to connect the appliance to
the electrical power due to the risk of electric shock and/or fire.
• All broken and faulty components, panels and parts must only be
replaced with original Blomberg spare parts by a Blomberg Service
technician.
• Do not force the washer door open when it is locked. The door
