Blomberg TKF 1230, Operating Instructions Manual

Page: 6 / 16

Before Drying
What can be dried
• The laundry should have been spin-dried
as much as possible – as long as the type
of textile permits it. Always follow the care
symbols on the labels!
•
Dry only laundry with appropriate sign
on them – and only in the appropriate
program.
•
Put in similar pieces; thin dish towels
dry faster than thick bath towels.
•
Remove metal part (belts etc.) or use a
cloth bag.
•
Empty out pockets; remove all foreign
items (coins, pens etc.)
Close all zippers, hooks and eyelets.
What must not be dried
Do not put in any soaking wet laundry.
The appliance could get damaged; the
energy consumption will be very high.
-
Sensitive textiles (silk, curtains etc.)
could wrinkle.
Electrical connection
Connect the appliance to an appropriately
installed and sufficiently protected plug.
Important:
•
The connection has to adhere to the
regulations of your country and
electricity supplier.
•
The electrical cable as to be reachable after
installation.
•
With a permanent connection a main
switch with at least 3mm connection
distance has to be used.
•
Current and fuse protection of the
appliance is available on the type plate
( on the back wall and behind the door)
- The current of the appliance can be
adjusted to the electrical infrastructure –
and safety calibration in your area.
To change the current consumption from
16 A to 10 A: Switch on the On/off-
switch. Adjust the program selector to
“Single Piece”.
Press the Signal-Deselecting-Button for
3 seconds.
The first two control lamps of the program
process indicator flash. After pressing the
“time delay” button only the control
lamp “Drying” flashes. Your appliance is
now adjusted to 10A.
If you press the “Time delay” button again it
will back from 10 A to 16 A.
Write down the Model and Id number
of the appliance from the type plate,
in case you need to call customer
service.
•
The declared current has to be the same
with your mains voltage.
•
A connection through an extension
cable or multiple sockets is improper.
•
During connection the On/Off –switch
has to be on Off.
Is the electrical cable damage, it has
to be replaced by an authorized
technician. The appliance cannot be
used until the repair! Risk of electric
shock!
The first time
•
Before drying the first time, clean off
the drum from any production residue
with a wet cloth.
•
During the first drying you might
experience a slight discomforting smell.
Care symbols for drying
Drying with high temperature:
White/colored laundry, cotton,
linen
Drying with limited temperature;
Easy care synthetics (Polyester,
Polyamide); mixed fabrics (with
cotton)
Drying in the drier not possible
are:
Sensitive fabrics (Viscose, Silk etc.);
curtains