2
How to clean your dishwasher
Seite
13
Trouble shooting What, if....
Seite
14
The dishwasher will not run ..............................14
The cleaning results are unsatisfactory ............15
Technical Data
Seite
21
Directions for assembly
Safety notes for installation...............................21
Installing your dishwasher.................................22
Water connection ..............................................22
Water drainage..................................................23
Electrical connection .........................................23
Seite
21
Service
Seite
23
7
8
9
10
11
Cleaning the filters ............................................14
Cleaning the spray arms ...................................15
Cleaning the filter inset .....................................15
21
Load capacity
10
Permissible water pressure 0,3 10 bar (= 3 100 N/cm²
= 0,01-1,0Mpa)
Electrical connection
230 Volt, 10 Amps
(see type plate)
Total power
2000 W
Heater power
1800 W
Because we continually strive to improve our products,
we may change our specifications and designs without
prior notice.
This device corresponds to the following EU
Directives:
73/23/EC
Low Voltage Directive
89/336/EC
EMV directive
93/68/EC
CE identification directive
DIN EN 50242
Electric dishwasher for
domestic use Testing method
for utilization properties
Safety notes for installation
Prior to installing and using your machine, please check
it for possible transport damage.
If the machine is damaged, please contact your supplier.
Never install and use damaged machines.
The following directions must be observed in order to
connect the dishwasher properly.
Make sure that the data on the type plate correspond
to the current and voltage of your power supply
connections before putting the machine into operation.
The connection of the machine may only be made
using a properly grounded socket. Ensure that the
grounding is in accordance with regulations.
The grounded socket must be easily accessible and
close to the machine.
Do not use extension cables or multiple adapters.
There is a possibility of fire hazard through overheating.
Hardwiring may only be carried out by a qualified
electrician.
Check the power cable, the water inlet hose and the
drainage hose. Damaged parts may only be exchanged
by customer service personnel or by a qualified
electrical service expert.
Technical features
9
Directions for assembly
10
