BLODGETT
www.blodgett.com
44 Lakeside Avenue, Burlington, VT 05401 • Toll Free: (800) 331-5842 • Phone: (802) 860-3700 • Fax: (802) 864-0183
SC-DS CONVECTION STEAMER
SHORT FORM SPECIFICATIONS
Provide Blodgett model SC-6DS (6 pan), SC-10DS (10 pan) or SC-16DS (16 pan) convection steamer operating on direct steam. The SC-6DS and SC-10DS shall be mounted on a 24”
wide base (an optional 36” base is available). The SC-16DS shall be mounted on a 36” wide base. The SC-6DS is comprised of two 3 pan compartments. The SC-10DS is comprised of
two 5 pan compartments. The SC-16DS is comprised of two 8 pan compartments. Unit shall be constructed of satin finish 304 stainless steel with a one piece welded stainless steel cook-
ing chamber with coved corners. The door shall have a removable inner liner of stainless steel with full perimeter gasket seal, an outer liner of one-piece all welded stainless steel, and a
positive lock and seal mechanism with spring release. Each compartment shall have removable stainless steel pan supports. A stainless steel drip trough integrally connected to collect
and drain condensate with the doors open. The control housing shall be constructed of stainless steel with a full access removable panel. The controls shall include an on/off power switch
with LED, a ready indicator light, cooking indicator light, and a 60 minute electric timer with audible alarm that signals the end of the cook cycle. Steam flow to the compartment shall be
cut off when the door is opened during the cook cycle and shall be reactivated when the door is closed. The cabinet base shall have full perimeter painted angle iron frame, reinforced
counter, stainless steel exterior, hinged doors and 6” (152 mm) stainless steel legs with adjustable bullet feet on the front and flanged feet on the rear for securing to floor. Provide options
and accessories as indicated.
WATER SUPPLY:
Water quality is a major factor affecting the performance of your steamer. If you
are unsure of water quality, consult a local water treatment specialist and have the
water analyzed. Your water supply must be within these general guidelines:
Total dissolved solids: Less than 60 PPM
Total alkalinity: Less than 20 PPM
Silica:
Less than 13 PPM
Chlorine:
Less than 1.5 PPM
pH Factor:
7.0 - 8.5
Water which fails to meet these standards should be treated by installation of a
water conditioner. Failure or malfunction of this steamer due to poor water quality
is not covered under warranty.
WATER & DRAIN CONNECTIONS:
Drain
2” (51mm) IPS piped to open floor drain. No solid connection.
24” length before open air opening (no bends or elbows)
Cold Water
3/8” (10mm) tubing at 25-50 PSI (170-345 kPa)
STEAM CONNECTIONS:
3/4” inlet for incoming steam at a minimum of 80 lbs/hour
at 10 psi (36kg/hr at 69 kPa).
POWER SUPPLY:
1/2” (13 mm) conduit connection to controls. 2 amps per
compartment
SHIPPING INFORMATION:
Approx. Weight:
w/24” base
w/36” base
SC-6DS
500 lbs. (227 kg)
550 lbs. (249 kg)
SC-10DS
600 lbs. (272 kg)
650 lbs. (295 kg)
SC-16DS
n/a
750 lbs. (340 kg)
Printed in U.S.A.
NOTE:
FOR COMMERCIAL USE ONLY
NOTE:
The company reserves the right to make
substitutions of components without prior notice.
APPROVAL/STAMP
P/N S00031 Rev E (12/06)
