Blocks One
3D Printer User Manual
www.blockstec.com | [email protected]
6
LOAD FILAMENT
1.
Press the Knob and go to Control
!
Filament
!
Load.
2.
Wait until the hotend reaches the appropriate temperature.
3.
Pull the extruder hindge while inserting the filament (aproximately 2,5 cm) in the
extruder hole . (Figure 3)
4.
Select insert and press, check if the filament being pulled.
5.
Wait until the extruder stops (it may take a minute).
6.
Remove the extruded filament.
(Figure 3 – Extruder Hindge Detail)