x6
x12
30
Nm
4
TIGHTEN ALL BOLT ASSEMBLIES WITHIN THE CIRCLE TO SPECIFIED TORQUE. ENSURE ALL
UPRIGHTS ARE PLUMB. DRILL AND SECURE THE MIDDLE HOLE ON EACH UPRIGHT AS SHOWN
IN GUIDE. REMOVE ALL BOTTOM CROSSMEMBERS, DRILL AND SECURE REMAINING HOLES ON
UPRIGHTS AS SHOWN IN GUIDE. REATTACH THE BOTTOM CROSSMEMBERS .
10.0031
10.0019
VACUUM
HAMMER
IN BOLT
10.0031
10.0019
SLEEVE ANCHOR
BOLT FITTING
-DRILL
10MM HOLE
THROUGH
FLOOR
COVERING,
90MM DEEP
USING PLATE
AS A GUIDE.
-VACUUM
OUT THE
DUST.
-HAMMER
SLEEVE
ANCHOR
DOWN INTO
THE HOLE.
-TIGHTEN
SLEEVE
ANCHOR TO
SPECIFIED
TORQUE
USING 13MM
SPANNER.
#MADEINBELFAST
xx
Nm
90MM
DRILL
HOLE
TIGHTEN
x50
