Blizzard SPEEDWING 7600HD, Owner'S Manual

Page: 15 / 24

Lit. No. 57992, Rev. 02 15 April 15, 2021
OPERATING YOUR SNOWPLOW
DISC SHOE ADJUSTMENT
Recommended Shoe Adjustments
For gravel surfaces: The bottom surface of the shoe
should be 1/4" to 1/2" below the cutting edge.
For hard surfaces (concrete or asphalt): Bottom
surface of shoe should be even with the cutting edge.
1. Raise the blade one foot o ff the road surface.
From in front of the blade, place stand assembly
or sturdy blocking under the cutting edge.
2. Lower the blade onto stand assembly.
3. Remove the linchpin and slide the disc shoe down
and out of the shoe holder.
4. Remove one or more washers from the shoe
stem, and reinstall the shoe into the shoe holder.
Place the removed washers onto the shoe stem
above the shoe holder.
5. Reinstall the linchpin.
6. Raise the blade slightly. Remove the stand
assembly.
7. Stand 8 feet clear of the blade when checking the
height adjustment of cutting edge to road surface.
WARNING
Blade can drop unexpectedly. Place blade on
stand assembly. Failure to do so could result
in serious personal injury.
Washers
Shoe Holder
Spacer
Linchpin
Disc Shoe
To pin wings in position for straight blade option:
1. Fully angle the blade to one side. Lower the
blade and turn the vehicle ignition OFF.
2. Standing behind the blade, install a
3/4" x 9" clevis pin down through the holes in
the back of the blade assembly, as shown.
3. Secure the pin with an 1/8" hairpin cotter.
4. Repeat Steps 1–3 on the opposite side.
5. To remove the clevis pins, reverse the above
procedure.
1/8" Hairpin
Cotter
3/4" x 9" Clevis Pin